How to make curtains with a rare window placement in a bedroom
The oddly placed windows add character to a room and create a focal point, but can cause problems with the curtains . The most common problem with windows placed so unusual is the lack of space for a bar curtain conventional, which can be adjusted a wire, a rail or bar extensible. These types of rod, however, only withstand a shade lighter, which may not be sufficient to block light in a bedroom. To address this, consider adjusting a shutter or external light-proof curtain and maintain curtain for decorative use only.
It measures 1 inch (2.5 cm) horizontally from each upper corner of the window and mark the point. Measures 6 inches (15 cm) up from each brand and make a cross in pencil. Drill a hole through each cross and adds an anchor.
Measuring the distance between the two anchor holes and cuts the wire curtain to this extension. Screw a hook in the adjustment of the wire at one end, leaving the other removed by Now jump hook. Screwing an eyelet in each hole in the wall anchor.
Measure the height of the window and adds 2 feet (60 cm) to fit. Measure the width of the window and multiply by 2. Cut a piece of fabric to these dimensions and spread it face down.
Fold the bottom hem of the fabric 1 inch (2.5 cm) and press along the seam. Fold back 1 inch hem to create a double. Press along the hem and sets in place. Machine Sew along the seam.
Double folded hems 1 inch (2.5 cm) on each side of the fabric and pressing, and comprises machine-sewn. Make a 1-inch hem at the top of the fabric and sewing machine, leaving the ends of the open seam. Ata well any loose end of cotton. Press the curtain completed.
Pushing on the wire curtain without a hook through the upper hem curtain . When the wire emerges from the seam of the curtain , the other hook screwed into place. Extends joints of curtain with your fingers and slide the wire hooks on the wall eyelets.
It measures 1 inch (2.5 cm) from each upper corner of the window, and then measure 6 inches (15 cm) up from that point. Make two crosses in pencil. Drill through each cross and put a wall anchor.
Measure the distance between the two holes and cut the rail curtain to the correct length with a jigsaw. Screw the rail to the wall with a screw through each of the drilled holes. Most rails curtain have molded continuous holes that can be set in any position. Otherwise, you need to make holes in the rail itself.
Measure the distance from the rail curtain to the bottom of the window and adds 2 feet (60 cm). You can choose to add more if you want a shade longer. Measure the width of the window and multiply by 2. Cut a piece of fabric to these measurements. Spread the fabric with the right side down.
Fold, press and hem comprises a 1-inch (2.5 cm) and the sides of the fabric. Sew machine in place. Fold and press a single hem 1 inch (2.5 cm) on the top edge, folding the fabric once.
Header tape extending along the upper seam of the fabric, placing half inch (1.2 cm) below the folded hem. Header tape should hide the raw edge of the fabric. Put it in place and then machine sewn. Finish neatly any loose end of thread. Match the curtain pulling the strings of the tape header. Knotted ropes and tape head screwed with hooks curtain . Slide the hooks on the rail curtain to hang.