Many times the washer and dryer in the kitchen end. It is impossible to hide the washer and dryer in a small kitchen. You can build a cabinet around these appliances. Thus will be hidden and you will have more room for storage.
Level of difficulty:Moderately difficult
With tape measure, a ruler and a pencil to mark, mark six wood two by four for measuring 5 feet (1.5 meters) long. Measure and mark four two by four wood for measuring 3 1/3 feet (1.016 meters) long. Measure and mark two four three wood width you choose. The width should be equal to the washer and dryer together plus 1 1/2 feet (0.45 meters). These three boards are placed horizontally on the supports to provide support to the shelf and keep tight the cabinet frame.
With a circular saw cut the table to make it the size chosen. Be sure to use protection for your eyes whenever you use a circular saw.
Mark two entre chapados for that measure 3 1/2 feet (1.06 meters) wide and 5 feet (1.5 meters) high with the help of a tape measure, a ruler and a pencil to mark. These will be the sides of your cabinet. Measure and mark another entre chapados for measuring 3 1/2 feet (1.06 m) wide by the width of your cabinet. This will be the shelf.
Entre chapados Cuts with Saw Circular. Use protection for your eyes.
Use the cordless drill and wood screws 4 inches (10.1 cm) to adjust the four March 4 1/2 feet (1.06 meters) on the ground to 1 1/4 (0.3 m) the left side of the washer. Do the same on the right side of the dryer. Place a two by four 5-foot (1.5 m) that is perpendicular to the floor on both sides of the washer and dryer. To adjust the sides, screws placed in the angles of the two by four right floor and the wall. Insert screws every 5 feet (1.5 meters). It uses two two by four over 5 feet (1.5 meters) to create stands at the opposite end by inserting screws into the bottom corner to pass through the two by four that is in the floor. Inserted a central support on each side, in the same way. Use the last two two March 4 1/2 feet (1.06 meters) and place over the three brackets on each side. Adjust it to the supports with a screw passing through the table and between by the brackets.
Entre chapados places the sides of each side with the cordless drill and screws one inch (2.5 cm). Place the rack on the unit. Adjust it with screws 1 inch (2.5 cm) and make sure they sink into the brackets underneath.
Measure, mark and cut two pieces of entre chapados for measuring 5 feet 4 inches (1.3 meters) high and half the width rack. These are the doors. The doors should be opened to gain access to the washer and dryer. Cut and place doors hinged Use screws 1/2 inch (1.27 cm) and the cordless drill to adjust the hinges to the wood, get help for you to hold the doors in place. Uses a leveling tool that doors for couples .
Paint the cabinet according to your decor.