Living Room Design Modern Architecture

How to make fluffy fabric rosettes curtain

The fabric rosettes are a decorative accessory used to beautify curtains. Add them to a strip to pick up the curtains, attach them to a frame of fabric or tassels suspend them to cover the structure of the curtains. Make your fabric rosettes with the same fabric as the curtains or use a fabric that combine to complement the style. These fabric rosettes require basic hand sewing to make. Sew a couple to add to the brackets or make several to add to your clothing window.


Cut a piece of fabric of 8 inches (20 cm) wide and about 24 inches (60 cm) long with scissors fabric. This will make a rosette fluffed which measured about 4 to 5 inches (10 to 12.5 cm) in diameter, depending on the thickness of the fabric.

fabric rosettes curtain


Fold the fabric strip in half, with the rights faced with the short ends together. Fixed the ends and make a seam-half inch (1.2 cm) to Fornar a ring. Press the seam open.
Fold the cloth ring wrong side out so that the long edges facing messy. Fixed pins and press the fold. The right side of fabric will show.

Thread the needle with thread that combine hand and make a seam of 1/4 inch (6 mm) with straight stitches along the edge sloppy, leaving a tail of thread on each end. Make a second row of stitches about 1/4 inch of the way to make it easier to assemble it. Use long stitches 1/4 inch soft pleats.

Pulling the four queues at both ends of the thread to raise the fabric. Pull the thread tight and tie the tails to form a knot. Make a second knot to be safe and cut the excess thread.

Sponge the rosette or match the gathers around the circle.

Make a second rosette using fabric cut 6 by 20 inches (15 by 50 cm), following the same steps. The second rosette add more depth to the other and will appear more abundant.

Covers the button on the set of buttons covered with a piece of the same fabric or cloth that combine to create the center of the rosette. Use a button long enough to cover the ragged edges of the rosette ruffled. Follow package directions to use the tools included. The coated button has a handle that will join up button to secure.

Place covered button on the rosette. Thread the needle with buttonhole thread. Pass the thread through the button shank coated and tie to secure. Passing the needle through the hole in the center of the rosette small, then through the center of the rosette large and one of the holes in the flat button. Gives a stitch through the other hole and back through the hole and around the rod several times to ensure the shank flat button. Tie a knot in the back of the flat button and cut the excess thread.

Sets the button overlay to cover uneven edges in the center of the rosette and sponge the fabric so bulky look good.